T2+Shipping
- Total activity 48
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by T2+Shipping-
Harmony A1 Solo - Can I Use the Speaker While Charging?
Yes, you can use the speaker while charging. Simply connect it to a power source (5V/2A) using the provided charging cable, and the speaker will function normally while charging.
-
Harmony A1 - How to Factory Reset / Clear Pairing History?
If your devices fail to connect or you want to remove old Bluetooth connections, follow the steps below to reset them.(Note: Reset only clears classic Bluetooth pairing; it does not affect Auracast...
-
Harmony A1 - How to Fix Audio Cutting Out When Connecting With Phone?
If audio cuts out when your phone is connected to the Harmony A1 transmitter via Bluetooth, please check the following:Stay Within RangeKeep your phone within 15 meters (50 ft) of the transmitter.R...
-
Harmony A1 - How to Increase Volume？
If the sound is too low, adjust the volume from the following controls:TransmitterPress the “+” button on the Harmony A1 transmitter to raise the volume.SpeakersPress the “+” button on each speaker...
-
How to Extend the Range of Avantree Harmony?
To increase the coverage area of your Avantree Harmony speakers, you can use the following method:Purchase an Additional Receiver: Obtain an Auracast receiver, which is compatible with extending th...
-
Harmony A1 - Buttons, Indicators & Function Table
Speaker Overview Button FunctionsNo.ButtonFunction①Power- Press & hold for 2 seconds to power the speaker on or off②M- Double-click to switch between Auracast Broadcasting a...
-
Harmony A1 - Interactive Setup Guide (User Manual)
English: Interactive Setup Guide (English)German: Interaktiver Einrichtungsleitfaden (Deutsch)French: Guide d’installation interactif (Français)Italian: Guida interattiva alla configurazione (Itali...
-
AuraBand - AuraBand Won’t Connect
If AuraBand won’t connect and the white light keeps flashing, it means AuraBand is searching for an available Auracast broadcast.Please try the following:Make sure there is an active Auracast broad...
-
AuraCoil - No Sound
If you cannot hear any audio through your AuraCoil, try the following:Make sure AuraCoil is powered ON.Set your hearing aid or cochlear implant to T or MT mode.AuraCoil works through the Telecoil (...
-
Harmony A0 Solo – Factory Reset
Old Bluetooth pairings may block new connections; reset clears only classic Bluetooth, not Auracast connections.Quick Check 1. Turn on the speakerMake sure the Harmony A0 Solo is powered on.2. Ente...